CAN BUS Autotronic Training System The KL-800A CAN BUS Autotronic Training System is a distributed control system supported by advanced serial bus system CAN (Controller Area Network). CAN is a multi-master bus with an open, linear structure with one bus line and equal nodes. The number of nodes is not limited by the protocol. Each module of KL-800A system is an ECU or the interoperable device (node) on CAN BUS. Data transfer between modules is achieved by the micro-controllers over CAN BUS. When signals and data are sent to personal computer, the computer monitoring system displays the current status and data of module on PC screen and turns on the warning light if something is wrong. The KL-800A system can simulate the operation of fuel injection system, ignition system and exhaust gas control. Experiments include the characteristic and operation of various sensors and actuators used in automobiles.- Crankshaft Position Sensor - Air-Flow Sensor (vane type) - Air-Flow Sensor Hot Wire & Manifold Absolute Pressure Sensor - TPS & CTS & O2 Sensor - P/N, A/C, PSPS, 3GR Switch & Vehicle Speed Sensor - Fuel Injectors / Spark Plugs - Cooling Fan & Fuel Pump & A/C Compressor Relays - Idle Air Control Valve - TCC & CCP & EGRV Solenoid- CAN-compliant modules can be easily connected together using the 9-pin D-sub connectors and cables.These modules can interoperate with each other. - User-friendly GUI design allows the user to display and control modules on PC screen. - Each module is equipped with fault simulation switches for troubleshooting practice.

Ltekonline are the manufacturers of CAN BUS Autotronic Training System used to demonstrate engineering principles in Engineering Colleges, Engineering Schools andAutotronics Systemfor Engineering Teaching Lab in Universities